Purchasing a new pair of suede or leather boots is an exciting experience. They are rich, long-lasting, and fashionable. New boots, on the other hand, tend to seem out of place. And they can be unpleasant since the relatively hard feel of these natural materials needs time to break in.
If you have a new pair of leather or suede boots, you want to give a classic, vintage appearance. So, here are some simple steps to get that distressed effect. Therefore, before you look for the best footwear for men, let’s know the tips.
Sand Down Them
Grabbing a piece of fine-grade sandpaper and gently rubbing your shoes or boots is one of the simplest methods to achieve. It distressed look for your leather or suede footwear. Take your time and pay particular attention to the areas of your shoes or boots that will naturally show greater wear and tear.
So, you don’t want to speed through this job and destroy a perfectly nice pair of shoes. After the sandpaper has worked its magic, apply a little coat of leather conditioner to your shoes or boots to seal the deal.
Booze Wet Boots
Polishing alcohol is a simple and inexpensive technique to give your leather boots or shoes a worn, antique appearance. Spray the alcohol in a spray bottle over your best luxury men’s shoes or boots. Focus on the natural grooves of your shoes using a sponge or a toothbrush for genuinely natural-looking wear.
So, squish, crumple, and wrinkle your shoes or boots while they are still moist. This will give your leather or suede shoes or boots a realistic worn appearance. Just be sure to wipe away any extra alcohol with a moist towel.
Brush This Up
Grab a stiff-bristled shoe brush and make random swipes over your shoes to impart a little more of a distressed effect. So, for a genuinely aged effect, pay careful attention to places where your shoes would naturally wear and tear.
Rock’ n’ Roll
Find a rock with a few jagged edges that fit well in your palms. To avoid perfect lines, rub the rock’s edges in irregular patterns. This is one of those projects where the raw and random look better. Scuff marks, not straight lines, are what you’re looking for.
Run Into Them
Lay the leather shoes or boots flat on a rough surface, such as a gravel path. The more textures you use, the better your results will be. So, place the boots at a location where you can run your automobile over them a few times.
When you’ve achieved the desired patterns and wear marks, flip the shoes over and continue on the other side.
Throw Them into the Dirt
Dirty shoes are unattractive. But you can achieve a beautiful vintage look by rubbing a few handfuls of dried dirt on your leather or suede boots and shoes. So, once you’ve achieved your desired outcome, brush off the dirt and condition the leather on your shoes.
Strike Them with a Hammer
Pick up a hammer and place your boots or shoes on a level surface. So, pound the shoes to create wear and tear marks, giving specific attention to the region around your toes and heels.
But don’t go too far. You want your boots or shoes to seem distressed rather than strained and damaged.